|
| |
|
Cheapham.com
by
Hometek
|
|
Quality
Amateur Radio, Broadcasting, Scanners and Marine Band Electronic Supplies at a Discount Price !
|
|
Alinco DJ-496T UHF FM Hand held Transceiver
Alinco has
created a new UHF FM Hand held Transceiver that sets new standards in features,
convenience and easy operation. The DJ-496T sports an alphanumeric display for
easy memory management. It has an ergonomic design that's "user
friendly" and the 4 watt output battery is standard. You'll be ready to
travel the world with CTCSS encode+decode, DCS and European tone bursts, all
included at no extra cost. Best of all, the DJ-496T retains the proud Alinco
tradition of quality construction and excellent value.
• Alphanumeric display
• 40 memory channels + Call Channel
• Backlit Keypad
• 4 watt output with standard battery
• CTCSS encode+decode and DCS
• 13.8 VDC direct input with battery charge feature
• Direct frequency input
• S-meter
• Autodialer
• Cable Cloning
• Computer programmable (third party software required)
• MARS/CAP capability
• Additional features, including theft alarm!
| Alphanumeric Display |
Label channels in an easy-reading format. Display frequency, alpha
label or channel number only. |
| 40 Memory Channels + Call Channel |
Plenty of room to store your favorite simplex or repeater frequencies
along with alphanumeric label, offset, CTCSS encode/decode or DCS
setting. |
| 4 watts output |
The standard battery allows the DJ-496T to produce up to 4 watts. A
power input port
Accepts 13.8 VDC and charges the battery, but won't allow destructive
overcharge.
|
| CTCSS, DCS, Tone Bursts and DTMF |
Be prepared for virtually any selective calling situation or gaining
access to repeaters with protected inputs. European Tone Bursts include
1000, 1450, 1750 and 2100 Hz. |
| Direct Frequency Input |
Frequency entry is easy using the well-spaced keypad. |
| S-Meter |
Displays relative signal strength. |
| Cable Cloning |
Share identical settings among multiple DJ-496T transceivers. Saves
time and ensures uniform operation. |
| Theft Alarm |
The DJ-496T can be set to emit a tone when disconnected from an
external power source until proper action is taken to silence the alarm. |
| Experimental Insect Repel Feature |
Can the DJ-496T actually repel mosquitoes? Activate the special tone
and decide for yourself! You may find the DJ-496T can "de-bug"
your outdoor operating site! |
SPECIFICATIONS
|
|
| General |
DJ-496T |
| Freq. RX original status |
430 to 449.995 MHz |
| Freq. Stability |
+/-5 ppm |
| Antenna Imp. |
50 ohm unbalanced |
| Supply Voltage |
DC 13.8V rated |
| |
DC 7.0min to 16V max |
| Ground |
Negative GND |
| Current consumption |
TX 5W 1.4A approx. |
| at 13.8V external source |
RX 200mA approx/280mW |
| |
RX squelched 50mA approx. |
| |
RX Batt.Save on 20mA approx. |
| Operating Temp. range |
-10 to +60 degrees C. |
| Dimention w/o projection |
56(W) x 124(H) x 40 (D) |
| Weight with EBP-48N |
Approx. 375g (13.2oz) |
| Transmitter |
|
| Output power |
5W 13.8V or 4W EBP-48N |
| |
Low=0.8W |
| Modulation |
Variable reactance FM |
| Max. Deviation |
+/- 5kHz |
| Spurious emission |
less than -60db |
| Microphone Imp. |
2k ohms approx. |
| |
|
| Receiver |
|
| Circuit |
Double superheterodyne |
| 1st IF freq. |
45.1Mhz |
| 2nd IF freq. |
455khz |
| |
|
| Sensitivity 12db SINAD |
better than -12dBu |
| |
(0.25uV or less) |
| |
|
| |
|
| Selectivity |
more than -6dB/12kHz |
| |
less than -60dB/26kHz |
| Audio output power |
280mW |
| Audio impedance |
8 ohms |
| |
|
|
Specifications subject to change without notice or obligation.
Specifications apply to Amateur Radio bands only.
Permits required for MARS/CAP use.
Product intended for use by properly licensed operators.
Cellular frequencies blocked in USA
No warranty is made on performance of experimental insect repel feature.
|